MERCK/HITACHI
|
|
|
The 03-CVG, 02-CTVG and 01-CVG may be used in some trays
without a support sleeve. If replacing a 2mL vial (2-SV) and
a wider flange cap (8-SCJ) then a SV-S12A must be used.
|
|
|
| Table
4 |
VIALS
USING 8mm
SCREW CAPS |
| 1 |
2-SV
|
2mL,
clear glass, flat bottom, screw top vial. With 'write-on' patch |
| 2 |
2-SV(A)
|
2mL,
amber glass, flat bottom, screw top vial. With 'write-on'patch.
|
| |
2-SVG
|
2mL,
clear glass, flat bottom, screw top vial. Made from inert, CHROMACOL
GOLD™ grade glass. |
|
1.1-STVGº
|
1.1mL,
clear glass, screw top, tapered vial made from inert CHROMACOL
GOLD™ grade glass. Needs a TTS-312 support.
|
| |
06-PESV |
600µL,
polyethylene, screw top vial with an internal tapered profile. |
| |
06-PPSV |
600µL,
polypropylene, screw top vial with an internal tapered profile.
|
| |
RECOMMENDED
CAPS AND SEALS |
| |
8-SC |
Black
screw cap, no seal. Also available in red, white, yellow and
blue with the following codes: 8-SC(R), 8-SC(W), 8-SC(Y) and
8-SC(BT). |
| |
8-SCJ |
8mm,
black, screw cap, no seal. Has wider flange suitable for those
autosamplers which suspend the vial by the cap. Also available
in red, white and yellow with the following codes: 8-SCJ(R),
8-SCJ(W) and 8-SCJ(Y). |
| |
8-ST14X
|
1.4mm
thick blue silicone/clear PTFE seal. Pre-cut. |
|
| Table
5 |
LOW
VOLUME INSERTS FOR USE WITH 2-CV, 2-CVG, 2-SV(A), 2-DV, 2-DV(A) |
| |
02-MTVWG |
200µL,
clear glass, tapered low volume insert for use with 12x32mm
flat bottom, wide neck vial. Made from inert CHROMACOL GOLD™
grade glass. Needs MTS-1 support. |
| |
03-NV |
300µL,
clear glass, low volume, flat bottom insert for use with wide
necked vials. No support needed. |
|
| Table
6 |
LOW
VOLUME INSERTS FOR USE WITH 2-SV, 2-SV(A), 2-SVG |
| |
02-MTV |
200µL,
clear glass, tapered low volume insert needs MTS-1 support. |
| |
02-NV |
200µL,
clear glass, low volume, flat bottom insert. No support needed. |
|
| Note 6 |
03-FISV |
Available
July 1998. |
|
|
|
|